"Bit 7 of Register 0 is the clock halt (CH) bit. When this bit is set to 1, the oscillator is disabled. When cleared to 0, the oscillator is enabled. On first application of power to the device the time and date registers are typically reset to 01/01/00 01 00:00:00 (MM/DD/YY DOW HH:MM:SS). The CH bit in the seconds register will be set to a 1."(El bit 7 del Registro 0 es el bit de parada del reloj (CH). Cuando este bit se establece en 1, el oscilador está deshabilitado. Cuando se borra a 0, el oscilador está habilitado. En la primera aplicación de energía al dispositivo, los registros de hora y fecha se restablecen normalmente a 01/01/00 01 00:00:00 (MM / DD / AA DOW HH: MM: SS). El bit CH en el registro de segundos se ajustará a 1.)
"Bit 7: Output Control (OUT). This bit controls the output level of the SQW/OUT pin when the square-wave output is disabled. If SQWE = 0, the logic level on the SQW/OUT pin is 1 if OUT = 1 and is 0 if OUT = 0. On initial application of power to the device, this bit is typically set to a 0."(Bit 7: Control de salida (OUT). Este bit controla el nivel de salida del pin SQW / OUT cuando la salida de onda cuadrada está desactivada. Si SQWE = 0, el nivel lógico en el pin SQW / OUT es 1 si OUT = 1 y es 0 si OUT = 0. En la aplicación inicial de potencia al dispositivo, este bit normalmente se establece en 0.)