Hola amigos
Aqui les posteo este proyectito , solo segui las especificaciones de los fabricantes y realice los pcbs,asi como las respectivas pruebas.
Tengo funcionando desde hace varias semanas el ampli y a mi gusto tiene muy buen sonido.Se trata de un amplificador con ci tda2050 ,incluyolas caracteristicas :
The TDA 2050 is a monolithic integrated circuit in Pentawatt package, intended for use as an audio class AB audio amplifier. Thanks to its high powercapability the TDA2050 is able to provide up to 35W true rms power into 4 ohm load @ THD =10%, VS = ±18V, f = 1KHz and up to 32W into 8ohm load @ THD = 10%, VS = ±22V, f = 1KHz.
Moreover, the TDA 2050 delivers typically 50W music power into 4 ohm load over 1 sec at VS=22.5V, f = 1KHz.The high power and very low harmonic and cross-over distortion (THD = 0.05% typ, @ VS = ±22V,PO = 0.1 to 15W, RL=8ohm, f = 100Hz to 15KHz)
make the device most suitable for both HiFi andhigh class TV sets.El diagrama
http://img20.imageshack.us/img20/8388/tdaesquema.jpgAl ser stereo solo se duplica el circuito , uno por cada canal.Si desean conectar más de una bocina(speaker,parlante,etc..)agregan otro.
Circuito impreso
http://img231.imageshack.us/img231/7098/tda2050pcb.png
Control de Tonos LM1036The LM1036 is a DC controlled tone (bass/treble), volume and balance circuit for stereo applications in car radio, TV and audio systems. An additional control input allows loudness compensation to be simply effected.Four control inputs provide control of the bass, treble, balance and volume functions through application of DC voltages from a remote control system or, alternatively, from four potentiometers which may be biased from a zener regulated supply provided on the circuit.
Each tone response is defined by a single capacitor chosen to give the desired characteristic.
Features
■ Wide supply voltage range, 9V to 16V
■ Large volume control range, 75 dB typical
■ Tone control, ±15 dB typical
■ Channel separation, 75 dB typical
■ Low distortion, 0.06% typical for an input level of 0.3 Vrms
■ High signal to noise, 80 dB typical for an input level of 0.3
Vrms
■ Few external components requiredDiagramaEl circuito enmarcado despues de la salida es opcional , agregue esta otra etapa amplificadora para exprimir la potencia de los tda2050.No recominedo ganancia mayor a 3.Solo cambien R10 y R15 por 10K ,22K o 33K
http://img205.imageshack.us/img205/9084/tonecontrol.jpg Para alimentar el circuito necesitaran una fuente que entregue +-22v maximo y 5Amperes minimo (TDA2050) Colocar unos buenos disipadores xD Minimo un capacitor 4700uF por rama.Filtren bien su fuentecita Para el control de tonos necesitan alimentardo de +9v a +15v todos los capacitores no polarizados son de polyester,pueden usar cerámicos solo para el control de tonos pero en el ampli los veo remplazables |
adjunto los archivos de eagle.
Más tarde seguire completando el hilo.
Saludos y buen sonido xD