PIC-Tengu

[moorat]

i m try modified version but tengu not run again. i m using that schema on attached.

[jfmateos2]

Hi moorat, I see you are using Diego´s single face pcb version.

Did you take into account the solder on LM358 pins?



Watching your video it seems that your PIC-Tengu is working, but slower than normal (I can see the flame animation but with a very low refresh rate)... I think you should review your Xtal. Are you using a 20MHz Xtal?

[moorat]

i'm using 20mhz xtal and solder on lm358n pins. i'm writing your modified firmware no light led's. but i'm using my firmware led lights on video. i'm attached my firmware

[Nocturno]

Can you link your hex file?

I think you have a problem with fuses and your micro run with Internal Oscillator.

[moorat]

my hex file for 18f2550

[Nocturno]

Yes, you have a problem with FUSES.

I think is solved in this hex. You can try

[moorat]

not run 

[Nocturno]

 

[jfmateos2]

Hi Nocturno. which fuse was wrong in moorat´s HEX file?

[jfmateos2]

Hi moorat, you can download all the files here: www.villatic.org/carpetaJuanfe/pictengu.rar

I recommend you to use V1, as it includes a small program (in softwareWindows folder) that allows you to easily change PICTengu messages.

[moorat]

not connect on software. i have a java virtual machine and i install MCHPFSUSB restart my pc but not connect software tengu.

[jfmateos2]

You must keep PICTengu´s reset button pressed while you connect it to the USB port (the eyes should blink alternatively)...

[Nocturno]

Qué raro se me hace hablar contigo en inglés  

When I open the moorat's HEX in Winpic800 I can see the fuse XT in Oscillator, and "No divide" in Oscillator Selection

[jfmateos2]

That´s very odd Nocturno... I have just opened moorat´s hex file using WINPIC800 and I see HS in "Oscillator" and Divided by 5 in "Oscillator Selection"

[Nocturno]

You're right, I reloaded and it has gone well. I do not know why it went wrong before.

The new automatic Google translator is a wonder